Download User`s Manual

User's manual
K&F SEQUENZA 5 incl. accessories
Horizontal setup:
Line up all required transport cases next to one another. You can completely set up all three
speakers from one transport case without having to separate the speakers from one another.
1.
When setting up the
speakers, make sure you
can add another speaker
without obstacles.
If you want to set up a
complete triple, remove
the entire lid from the first
transport case and the lid of
the next transport case.
Position the transport cases
of all triples behind one
another so that the side of
the first speaker's safety
catch is in front.
2.
Connect the SEQUENZA 5
flying frame with the top
SEQUENZA 5 W speaker,
as described in chapter
'Safe Connecting and
Disconnecting of the
Products' on page 21.
If you cannot connect the
speakers straightaway, it
is most likely because of
uneven ground. In this case,
slightly lift both speakers
under the connecting
point while sliding them
sideways so that the bolts
are inserted.
3.
Set the spring bolts of all
speakers by turning each
one 90° to the right into the
start position. 20Using the
Spring Bolt
KLING & FREITAG GMBH © 2014
Version 4.0
Page 44 of 87