Download Step Motor Controller User Manual

Transcript
5.4
Accessories
As an accessory to the Controller, JVL can supply a Connector Board type CON13. This connector
board enables connection via snap-lock terminals. The following illustration shows the connection facilities. The Connector Board can either be mounted at the rear of a 19” rack or on the Controller itself.
Connections
Connector Board for SMC20
Type: "CON10P"
Selection of Input Type
Each of the 4 User Inputs IN1, IN2, IN3 and ST. has a jumper.
If a given input receives a signal from a PNP (Source) output,
the associated jumper is set to "0".
If a given input receives a signal from an NPN (Sink) output,
the associated jumper is set to position "1".
Note that Input "ST" (Stop Input) is activated if a signal which is not
logic "1" is applied to the input. If the Input is not used, the "ST"
jumper must therefore be set to position "1".
"Pull-up/down jumpers"
(See diagram)
User Outputs
User Inputs
Status Outputs
User Inputs
Output ground
Output 1
Output 2
Output 3
Output supply +5VDC
Input ground
Input 1
Input 2
Input 3/EOT
Stop input
Move output
Ramp output
Input Supply +5VDC
Holes for mounting on Controller (Ø2.6)
Holes for rackmounting (Ø2.6)
1
ST.
IN3
IN2
IN1
OO1
O2
O3
O+
ININ1
IN2
ST
I+
0
A
B
P+
PA+
AB+
BAG
A6
A5
A4
A3
A2
A1
Direction
Step clock
Earth (Chassis)
Supply +15-45V
Supply Ground
Motor phase A+
Motor phase AMotor phase B+
Motor phase BAnalogue ground
Analogue input 6
Analogue input 5
Analogue input 4
Status Outputs
Controller Power Supply
Step motor
Analogue Inputs
Analogue input 3
Analogue input 2
Analogue input 1
These terminals are not used !
TT0233GB
Holes for rack mounting (Ø2.6)
Holes for mounting on Controller (Ø2.6)
5.4.1
Interface cable
2 types of cables is available.
Type RS232-9-1For PC-AT with 9 pole SUB-D connector.
Type RS232-25-1For PC-XT with 25 pole SUB-D connector.
5.4.2
PC software
2 types of software for PC is available
Type Editor2 dos based software
Type MotoWare Windows based software
Both programs makes it possible to communicate and program parameters, programs etc.
to the SMC20 step motor controller.
JVL Industri Elektronik A/S - User Manual - Step Motor Controller SMC20
62