Download Altus Digital Recorder - KMI Support WIKI

DOCUMENT 302200, REVISION I
Figure 51: Internal EpiSensor oscillator board
Table 17: Output voltage-level jumper settings
Axis
Header
2.5V Output
10V Output
X
X9
1-2
2-3
Y
X14
1-2
2-3
Z
X19
1-2
2-3
Because the internal EpiSensor is more sensitive to noise, it is not offered
with the low noise option available on EpiSensor ES-Ts.
Additional Jumper Settings
There are several additional jumpers on the oscillator board. Jumpers X1,
X2 and X3 are normally installed. If these are removed, the calibration coils
for each axis can be accessed, generally for factory test procedures.
140
ALTUS DIGITAL RECORDER USER MANUAL