Download Solidyne 562dsp AM

Transcript
7.1.5 STEREO CROSSTALK
Input: Audio generator at 1KHz on left input channels, adjust the AGC so it compress 15db.
Output: Connect a dB meter on right audio output
(XLR).
Procedure:
a) Select the program Nº26.
b) Take the output level of the left channel as reference of maximum level at the audio output.
c) At the right output you must obtain a crosstalk
bigger that 72dB (difference between the level
measured at the point b and the reached in the
point c).
d) Repeat for the other channel.
7.1.6 DISTORTION
Input: Audio generator at 1KHz on both input
channels, adjust the AGC so it compress 15db.
Output: Connect a dB meter on right audio output
(XLR).
Procedure:
a) Select the program Nº28
b) Under this conditions the audio output must be
-2dBm (6 dB below the nominal level of
+4dBm). By the other hand, no of the 4 bands
must enter compression.
c) Proceed to measure the total harmonic distortion (THD) It must be around 0.01 %.
d) Repeat for the other channel.
Page 40
SOLIDYNE 562dsp/AM – Broadcasting dsp processor