Download CIMPLICITY HMI Routing Control Objects Operation Manual

If the following error message displays,
"Source is already triggered.,"
Then
The source is already in a triggered state and cannot be triggered again.
Reset Triggers
You can reset a trigger, returning the source to a non-triggered state and restarting the
trigger sequence.
To manually trip a trigger:
1.
In the Control Site Trigger Display dialog box, select the Trigger to be reset.
2.
Click Reset Trigger.
A confirmation box will display.
3.
Click OK in the confirmation box to reset the trigger sequence. Click Cancel to
quit the operation.
Result: The Trigger will be returned to a non-trigger state and the trigger sequence
will be restarted. The resulting status and point ratio will display.
Reset Trigger Error Conditions
If you cannot launch the Control Site Trigger Display dialog box, the RCO system will
generate an error message.
If the following error message displays,
"Selected Control Site is not currently accessible,"
Then
The RCO process required to carry out the request is not currently online. This could
indicate a problem with RCO.
If the following error message displays,
"Source is already triggered.,"
Then
The source is already in a triggered state and cannot be triggered again.
4-29
CIMPLICITY HMI Routing Control Objects Operation Manual–July 2001
GFK-1408C