Download EIP Manual

Transcript
Image 8: New Module
4.2 RS Logix 5000 Configuration Release 13 Through 19
RS Logix 5000 release 13 through 19 supports the RF IDeas Ethernet IP based Reader. The EDS file
is not used in the RS Logix 5000 configuration.
The following steps will guide you through configuration using a Generic Ethernet Module.
Image 9: Generic Ethernet Module
1. Open the intended project in the RS Logix 5000 program.
2. In I/O configuration under the Controller Organizer, locate the Ethernet port.
©2014 RF IDeas Inc. Configuration User Manual
Page | 23