Download NEDSP1062-KBD PDF operating manual

Nut &
If the enclosure is too
keyboard
washer
thin to incorporate a
Front panel
countersunk screw
label
(such as fitting into
sheet metal) then it can
be retained by a
instrument
head
Front
screw.
panel
The label needs to be
Cut hole
cut out to allow the
Retaining
for
screw
screw
screw to pass through
from the outside. This Figure 4.
can be easily achieved Keyboard mounting 2.
by applying the label to
the panel, then carefully cutting around the screw hole,
with a sharp knife. Again do not over tighten the screw.
1. Introduction.
1.5 Sounder mounting.
Sounder
Backing paper
Cut a small piece of the
self adhesive foam
Self adhesive
foam
(supplied) to mount the
sounder.
Do not cover the small
hole in the face of the Keep this
hole clear
sounder.
For best results mount
Backing
the sounder where it
paper
can radiate sound to
the outside the case,
Case
for example on an air
vent.
Figure 5. Sounder mounting
Page 8
NEDSP1062-KBD Operating Manual