Download CS Series Programming Manual

Programming Manual
CS Series AC Current Source
OUTPut:PROTection:DELay
This command sets the delay time between the programming of an output change that produces
a CL or UNREG status condition and the recording of that condition by the Status Operation
Condition register. The delay prevents momentary changes in status that can occur during
programming from being registered as events by the status subsystem. In most cases these
temporary conditions are not considered an event, and to record them as such would be a
nuisance.
Command Syntax
Parameters
Unit
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands
OUTPut:PROTection:DELay<NRf>
0 to 32 | MINimum | MAXimum
S (seconds)
100 milliseconds
OUTP:PROT:DEL 75E-1
OUTPut:PROTection:DELay?
<NR3>
OUTP:PROT:CLE
*RCL *SAV
OUTPut:RI:MODE
This command selects the mode of operation of the Remote Inhibit protection. The following
modes can be selected:
LATChing
A TTL low at the RI input latches the output in the protection shutdown
state, which can only be cleared by OUTPut:PROTection:CLEar.
LIVE
The output state follows the state of the RI input. A TTL low at the RI
input turns the output off; a TTL high turns the output on.
OFF
The instrument ignores the RI input.
The RI output state is saved as part of an instrument setup using the *SAV command. It can be
made part of the power on setting if needed. The default state is LIVE.
Command Syntax
Parameters
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands
OUTPut:RI:MODE <mode>
LATChing | LIVE | OFF
OFF
OUTP:RI:MODE LIVE
OUTPut:RI:MODE?
<CRD>
OUTP:PROT:CLE
OUTPut:TTLTrg:MODE
This command sets the operation of the Trigger Out signal to either Function Strobe or Trigger
mode. Factory default is Trigger state which means the OUTP:TTLT:STAT command is required
to generate outputs. In Function Strobe mode, an output pulse is generated automatically any
time an output parameter such as current, frequency or phase is programmed. The AC source
Trigger Out signal is available at a SMA connector on the rear of the CS Series AC Current
source units.
Command Syntax
Parameters
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands
OUTPut:TTLTrg:MODE TRIG | FSTR
TRIG | FSTR
TRIG
OUTP:TTLT:MODE FSTR
OUTPut:TTLTrg:MODE?
<CRD>
OUTP:TTLT:STAT
58