Download MicroLite Overview

Sensors Tab
Use this tab to configure the specific logger inputs which should be run, in addition to
relevant alarm levels. A major feature of the DataSuite system is the ability to
configure alarm levels into the loggers so any breach of these levels is recorded on
the data logger and monitored by the software, if the unit is connected via USB. The
user may be notified of these alarms via Email/SMS/audible and visual indicators.
Alarm Delay
The time until the alarm is activated. You may not want to have the alarm sound
immediately after the alarm level is breached as you are only interested in a condition
where the alarm level lasted a certain amount of time.
For example, if monitoring change of temperature in a freezer, you would only be
interested in a High alarm which lasted more than one minute as anything else could
just be caused by the freezer door opening for a few seconds, as opposed to a power
failure leading to rise in temperature.
Sensor Configuration
Select the relevant checkbox to configure the logger internal and/or external sensors
to be used for measurement.
To enable Dew Point measurement on the EC850 or MicroLite II RH model, you must
select both the internal Temperature and Humidity checkboxes.
After selecting one or more of the sensor checkboxes, the Alarm checkbox is
enabled. Enter the minimum and maximum alarm levels dependent on your specific
thresholds.
189