Download MicroLite Overview

fourtec DataNet
Ready
Mark Unit on PC
To indicate the Repeater icon in the software’s Map View, press the Enter button
when this screen is displayed. The Repeater’s icon located in the Map View will blink
a number of times.
Batt Level (battery level)

If the power adapter is not connected the battery percentage will be displayed.

If the power adapter is connected Battery charging will be displayed.
Batt Level:
67%
Batt Level:
Battery charging
Signal Level Test
The Signal Level test allows the user to check the signal strength and quality of the
link between the Repeater and its parent unit. This test is used to determine optimal
positioning of the Repeater during deployment.
Signal level:
Run test -> Menu
Byspressing the Menu button the unit will show the signal level and link quality in
percentage terms.
If there is no connection with a parent unit, an Out of range message will be
displayed.
Signal level: 80
Link quality: 95
Out of range

Signal level: Indicates the reception level between end unit and parent unit. If the
level falls below 20% then the logger should be placed in a better location or
another Repeater should be added.

Link quality: Calculation of the data transmitted with no errors from the Repeater
to the parent unit. If the level falls between 85% then the Repeater should be
placed in a better location or another Repeater should be added. The lower the
link quality %, the more retries are needed in order for the Repeater to send all of
its data.
Note: The signal level may be low but the link quality can still be 100%.
You will not be able to run the Signal Level test when the Repeater has lost its
connection to the network. If you tried, then the following screens are displayed:
68