Download CPС152 User Manual

CPС152
User Manual
3.1.2
Installation and configuration
Purpose of IDE integrated devices: Master or Slave
Table 3-3:
Jumper
Purpose of IDE integrated devices: Master or Slave
Description
X3 [1-2]
Flash-drive: Primary Master
Compact Flash: Primary Slave
X4 [0-0]
X5 [0-0]
X3 [0-0]
Flash-drive: Primary Slave
Compact Flash: Primary Master
X4 [1-2]
X5 [0-0]
X3 [0-0]
Flash-drive: deactivated
Compact Flash: Primary Master
X4 [1-2]
X5 [1-2]
X3 [0-0]
Flash-drive: deactivated
Compact Flash: Primary Slave
X4 [0-0]
X5 [1-2]
3.1.3
Selection of power supply voltage for LCD panel (connection via KIB98102,
XP15)
Table 3-4:
Selection of power supply voltage for LCD panel (connection via KIB98102, XP15)
Jumper
Description
X6[1-2]
There was a selection of voltage of +5 V for power supply of LCD panel, connected via
KIB98102 module (XP15 connector of CPC152 module)
X6[2-3]
There was a selection of voltage of +3.3 V for power supply of LCD-panel, connected
via KIB98102 module (XP15 connector of CPC152 module)
3.1.4
Switching of Power Fail signals, watchdog timer actuation, remote access
to the line of CPU hardware reset
Table 3-5:
Switching of Power Fail signals, watchdog timer actuation, remote access to the line of CPU
hardware reset
Jumper
Description
X7[1-2]
Switching of Power Fail signal to the line of CPU hardware reset
X8[1-2]
Switching of watchdog timer (WDT2) actuation signal to the line of CPU hardware
reset (used for automatic switching to the BIOS backup copy in case of a boot
failure while booting from the main copy)
X9[1-2]
Switching of external signal of a remote reset / interrupt (from XP17, XP18 connectors) to
the line of CPU hardware reset
October 2015
3-3