Download VRM software TW2 issue1

Appendix D. SCPI command reference and
Description
Command
Parameter/Result
arameter/Result
Read/write
Sweep mode from
SYS:VRM:RVST:MODE
ASAP|TIME|RATE
read/write
present vector to
(SET:SYS:VRM:MODE:<P>
setpoint (as fast as
will be ignored unless sent
possible, in a specified
at the same time as VSET)
Float value (minutes)
read/write
read/write
time, or at a specified
overall rate)
Sweep time to vector
SYS:VRM:RVST:TIME
setpoint
(SET:SYS:VRM:TIME:<min>
will be ignored unless sent
at the same time as MODE
and VSET)
Sweep rate to vector
SYS:VRM:RVST:RATE
Float value
setpoint
(SET:SYS:VRM:RATE:<rate>
(Tesla/minute)
will be ignored unless sent
at the same time as MODE
and VSET)
Vector setpoint
SYS:VRM:VSET
If COO is:
(magnitudes in Tesla,
(SET:SYS:VRM:VSET: etc
CART then [x y z]
angles in radians)
will be ignored unless sent
CYL then [rho theta z]
at the same time as RVST
SPH then [r theta phi]
parameters)
magnitudes are in
read/write
Tesla.
Angles are in radians.
System status
SYS:VRM:ACTN
RTOS|RTOZ|HOLD|PERS
read
:NPERS:SAFE:IDLE
Sweep to the given
SYS:VRM:ACTN
RTOS
write
SYS:VRM:ACTN
RTOZ
write
SYS:VRM:ACTN
HOLD
write
vector, as specified by
the mode, and if
requested set persistent
on completion
Sweep to zero as fast as
possible and, if
requested, set persistent
on completion
Hold
Issue 01
May 2012
Page 49
VRM Software Manual
©2012. Oxford Instruments NanoScience. All rights reserved.