Download FastSCAN CobraTM
Transcript
36 FastSCAN Cobra 6.3.4 Object Limit You may find that your surface contains parts of background objects (such as the scanning table) that you did not mean to scan; the camera can pick-up partial profiles on objects behind the target object. You can use the Limit Objects to control to remove these extra bits of surface, but only if they are disconnected from, and smaller than, all the pieces of the main object. Check the Limit Objects to box and enter the number of objects N that you wish to be preserved. The export process will remove all the smaller objects, leaving only the N largest. If this method fails, you can: • Edit the Export Surface afterward using a separate application. • Rescan after covering background objects in a black cloth (or similar arrangement) in order to suppress the laser return from them. 6.3.5 Surface Information If you want to know some of the statistics of your surfaces, the Export Surface Control dialog box also includes this information. For the Raw Surface, it shows the number of sweeps, profiles, points and facets. For the Export Surface, it shows the number of points and facets and the surface area. 6.4 Batch Processing The batch processing interface allows you to setup the parameters for processing several scan files, then process them all at once. This replaces the old command line interface. Figure 20 shows the batch processing dialog. Select File / Export / Batch Process to open the Batch Processing dialog. On the left of the dialog is the list of scans to process. If you currently have a scan open it will be placed in this list, otherwise the list will be empty. The Add button, beneath the list, adds a new scan, copying the settings from the last scan in the list. If you want to process several scans with the same settings, then configure the first scan before adding the rest. To remove the selected scan from the list, use the Remove button. On the right of the list is group of controls for changing the settings for the currently selected scan. The top-most box displays the input scan file name, which cannot be changed. The Export Surface Control button opens the Export Surface Control