1
Download CE5000-40-CRP Manual
Transcript
Step 4 If no medium has been loaded, the message below appears on the display, prompting the loading of a medium. LOAD MEDIA!! If a medium has already been loaded, the current media setting is displayed as shown below. ROLL2 PRESS ENTR Select the media mode to suit the medium used. For instructions on loading media and selecting the media mode, see “2.3 Loading the Medium.” 2.3 Loading the Medium Load the medium, aligning it with the right-hand grit roller when viewed from the front so that it registers with the media sensor. Then, adjust the push-roller position to match the width of the medium. The cutting plotter can use media in roll or sheet form. Load the desired medium type by following the appropriate instructions. ■ Loading a Roll Medium Load the roll medium onto the roll-medium trays. Loading the Roll Medium on the Roll-Medium Trays Step 1 Place the roll-medium trays flush against the roll-medium-tray guide rail, and place the roll medium on top of them. Make sure the roll-medium trays are set on the correct side with the bearings facing outward. Roll medium Flush Roll-medium trays 2–4 Roll-medium-tray guide rail
