Download Vasona, User Manual

Limit Inject RF Current
Need analyser connected to the second device. In addition, a
current probe (or similar) is required.
Process is currently under development, but it allows Vasona
to limit the amount of current injected into a given line using
a current probe.
Need an analyser connected to the second device. In
addition, a current probe (or similar) is required. There are
options in the setup window to allow these to be configured.
Cal: Conducted
Cal: Radiated Fixed Voltage
Allows conducted calibration to be performed. For additional
information. See conducted calibration page.
Allows radiated calibration to be performed, establishing a
fixed voltage within the chamber. See radiated calibration
page.
Option needs to have an Isotopic field probe attached, noting
that Vasona currently only supports serial probes.
If forward power is to be recorded then the directional
coupler, power meter and power sensor needs to be included
in the template. See selection options.
Cal: Radiated Fixed Power
Check linearity [5dB]
Current method is not fully supported.
Allows the checking of the linearity of the test level obtained