Download PDF User Manual

Transcript
Chapter 6 - Forensic Acquisition
6.2
GETDATA’S FORENSIC IMAGER
Installed with Forensic Explorer is the standalone forensic imaging tool “Forensic
Imager”. Forensic Imager is a Windows based program that will acquire a forensic
image into one of the following common forensic file formats (described in more detail
later in this chapter):

DD /RAW (Linux “Disk Dump”)

AFF (Advanced Forensic Format)

E01 (EnCase®) [Version 6 format]
6.2.1
INSTALLATION
Forensic Imager is installed with Forensic Explorer into its installation folder:
C:\Program Files\GetData\Forensic Explorer v1\ForensicImager.exe
6.2.2
SYSTEM REQUIREMENTS
Forensic Imager should be run as local Administrator to ensure that sufficient access
rights are available for access to devices.
Forensic Imager requires the following minimum specification:

Windows 7 or above;

32 and 64bit compatible;

Pentium IV 1.4 GHz or faster processor;

1GB RAM.
Forensic Imager does NOT support DOS acquisition. If acquisition from a DOS boot disk
is required alternative forensic acquisition software should be used.
6.2.3
PROTECTED DISK AREAS - HPA AND DCO
Host Protected Area (HPA) and Device Configuration Overlay (DCO)
The HPA and DCO are two areas of a hard drive that are not normally visible to an
operating system or an end user. The HPA is most commonly used by booting and
diagnostic utilities. For example, some computer manufacturer’s use the area to
contain a preloaded OS for install and recovery purposes. The DCO “allows system
vendors to purchase HDDs from different manufacturers with potentially different
sizes, and then configure all HDDs to have the same number of sectors. An example of
this would be using DCO to make an 80 Gigabyte HDD appear as a 60 Gigabyte HDD to
both the OS and the BIOS” (1)
Copyright GetData Forensics Pty Ltd 2010 - 2015, All rights reserved.
49 | P a g e