Download G30 Hardware User Guide

Transcript
G30 Hardware User Guide
1VV0300919 Rev.0 – 2011-05-04
AT+MADIGITAL
Switches between analog and digital audio
paths.
Table 3-15: Advanced Mode Commands
3.9.9.
Audio Programming Interface
96B
The G30 incorporates a unique audio programming interface, through AT commands, which
controls the following audio features:
• Audio Path - Defines the input and output devices for speech, DTMF tones, rings and
alerts.
• Audio Gain - Defines the amplification (gain) level for input and output audio devices.
• Audio Algorithm - Defines the speech processing features for voice calls.
The next figure describes the audio programming interface options, which are defined by AT
commands.
Figure 3-22: Audio Programming Interface
3.9.9.1.
Audio Algorithms
125B
The G30 audio interface features advanced speech processing algorithms for echo
suppression, noise suppression and side-tone feedback.
Enabling or disabling the algorithms can be configured separately for each audio path and
operating mode through the AT command interface.
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights Reserved. Page 60 of 105