Download Data Review

DATA REVIEW MANUAL
14
REVISION 4.0
Analysis Tabs
To minimize screen change requirements and simplify viewing during
monitoring; key pile status calculations and other indicators, including
diagnostic information (all in the form of Analysis Tabs), are located
on the right hand side of the screen (red box). The Tabs are labeled
as follows:
 Configuration – providing a summary of the configuration data;
 Calculations – providing numerical results for some key
calculation points not visible in graphical displays;
 Capacity – providing a comparison of fixed Case method capacity
results vs. UF method results. Key pile health indicators are also
numerically displayed.
To simplify result interpretation during real-time monitoring, the
average calculated capacity (using the selected calculation
method) between the last and the current pile marker entry (the
so-called DBRef+1 value) as well as the average calculated
capacity between the next-to-last and the last pile marker entry
(the so-called DBref+2 value) are also displayed (blue box). If
these values are greater than or equal to the Nominal Bearing
Resistance entered by the user in the Pile Data sub-Tab, the field
will turn green. If both fields turn green (signifying 2 pile marker
increments of achieved bearing), the Nominal Resistance
Achieved indicator will also turn green.
The system will also check for a “pile refusal condition”, i.e. when
the DBR value increases less than 2 inches in 40 blows. In that
case the Nominal Resistance Achieved indicator will automatically
turn green, irrespective of the calculated capacity values logic
described in the previous paragraph. If the system indicates
refusal, the user should also confirm the condition is true before
the pile driving is ended.
Finally this tab includes the so-called MPI value. For the
interpretation of this parameter please refer to Appendix 3.
 Diagnostics – Provides a consolidated view of the SmartPile®
Acquisition Accel / Strain Data Tab diagnostics information.
Similar content is also contained in the State Stamp Tab.
Basic Data Review
Page 21
FOR EVALUATION PURPOSES ONLY