Download xp640 eprom programmer user`s manual - Matthieu Benoit

Transcript
fote |
1/
The cursor address is shown followed
by RAM data and
P R O M d . at a
bo th are hex FF in this
example.
2/
The video
always
shows a dump of RAM data.
PR0M
data at the corresponding
RAIr{ cursor
address
1s also
pR0M data
shown.
If
the
is
shown as '--'
then
the
cursor
is outside
the range of the se lected
EPROM (i.".
no PR0M data is available).
Ef,TER
This i-s used during
the course of hexadeeinal
data entry.
E.g. address and data inf ormation,
Fi11 parameter,
lock cod.e.
'YES'
It is also
an inplied
k"y to reply
to questions
asked by
the XP640.
The XP540 will
only
act on the data entry
once the ENTER key
has been pressed.
CLEAR
This
can be used to clear
a hex entry
E.g. if
been made.
it
is also
used as an inplied'N0'key
response to q.uestions asked by the XpG40.
Exanple:
Move the
cursor
to
address
a mistake
has
for use in
O13F and correct
KEYPRESS
DISPLAY
MEANING
( rll;
o13c
A D D R ES S
ADDRESS-o1'C
CLEAR
F
ADDRESSO15
ENTER
01 3F DE FF
pronpt
for memory
enter address but
is wrong
last
entry
eleared
0K now enter
th
digit
eursor
address
is
data DE, PR0M data
MEM
ItEt{ (ilerory
mistake
address
last
digit
e
correct
01JF,
FF
RAM
address)
This
moves the cursor
to any RAM address
within
the 64k x 8
user RAM. The base address of the RAI'l is 0000 and corresponds
to PR0M (Ztp)
add.ress 0000.
The last
address
of the RAll is
FFFF.
The last
address of the PROM depends on the size of the
device selec ted.
Page 9