Download Alba 355

5. FUNCTIONING
Refer to the following procedures for proper use of equipment:
• Read this entire instruction manual and ascertain that the installation was correctly performed.
• Check that all persons within the site where the equipment is installed wear safety goggles
• Verify that the switch on the back of the machine is in position O, then connect the power cord to the
mains supply.
• Place the main power switch on the back of the machine in position I.
• Turn the ignition key to start the power section of the laser; the light of white color "Laser Ready",
placed on the front of the machine, indicates the laser ready status. Simultaneously the control panel
will activate and – at the end of management software loading - the following screenshot will be
displayed:
WARNING
IN THE EVENT OF EMERGENCY PRESS THE RED BUTTON ON THE FRONT OF THE EQUIPMENT.
ALBA 355 user’s manual Rev. 1.0_4/2012
17