Download JDS Uniphase MAP Series User Manual

17
Figure 27: Master/Slave Chassis Typical Configuration
Installing an Optical Cassette
MAP allows for hot swapping of optical cassettes. The controller detects the presence and
determines the type of cassette being added or removed without affecting communication with other
cassettes.
Perform the following steps to install a cassette:
1. Using a screwdriver, unscrew the two screws and remove the blanking plate (or two, if
installing a double-width cassette) from the chassis. Store the faceplates for future use.
Caution
•
Use minimal force when sliding in the cassette during installation. Pushing the
cassette in too fast could damage the connector on the back plane.
2. Slide the cassette into the chassis. MAP automatically detects the presence of cassettes.
3. Using a screwdriver, screw in the two screws to secure the cassette.
Figure 28: Removing a Faceplate
Figure 29: Inserting an Optical Cassette