Download INSTALLATION & USER MANUAL

Transcript
INTRAC-605
10. REMOTE CONTROL TERMINAL
The .ini file parameters
Each parameter of the RCM.INI file is described in the Help
file. Most of the parameters in the .ini file are set from within
the RCM as described in this section under “Configuring the
RCM”.
Described below are the parameters which can only be set in
the .ini file, using a text edit package.
These parameters are :BeaconPolSelect
CSOEnable
ExtendedAz
newNamePromptEnable
BeaconPolSelect
This facility requires an, optional, beacon signal switch box.
The switch box can have up to four beacon inputs. Anyone of
the switch box inputs can be routed to the INTRAC beacon
signal input. “BeaconPolSelect” enables or disables the box
switching commands.
In the .ini file BeconPolSelect may be set to OFF, AB or ABCD.
If either AB or ABCD is set a button appears next to the IBR-L
Frequency box on the “Limits, Time & Frequency” screen.
Clicking on this button causes the character on it to change
between A & B or to step through A, B, C & D depending on
whether AB or ABCD is set in the .ini file.
Clicking on the button also causes the selection to be sent to
the INTRAC where it sets an output to switch the external
switchbox to route the required signal to the beacon signal
input.
CSOEnable
© 2011 Advantech Wireless
See Velocity on page 122 for a description of this facility.
ISSUE 4
Page 133