Download Polycom RSS 2000 User Manual

Polycom RSS 2000 User’s Guide
2. Call into the conference by using the endpoint controller to enter 'the E.164 number with which the RSS
2000 is registered to GK + the conference room number defined on the RSS 2000'.
3. After entering the conference, select Start Recording to start the point to point recording.
4. Call another endpoint into the conference by using the endpoint controller to enter 'the E.164 number with
which the RSS 2000 is registered to GK + the conference room number defined on the RSS 2000 + the E.164
number with which the other endpoint is registered to GK'.
5. After entering the conference, select Start Recording to start the point to point recording.
Pause Recording
You can use the endpoint controller to control and pause a recording. You can press any arrow key to go back to
the Record Archive menu from the loopback image screen or two-window screen. You can select Pause
Recording to pause the current recording process, when the Pause Recording option turns into Continue
Recording and the system provides a voice prompt of 'The conference recording is paused', as shown in Figure
2-12. In this case, the code stream sent to the RSS 2000 by the endpoint is not saved.
Figure 2-12 Pause Recording
Continue Recording
You can resume the paused recording by using the endpoint controller to select Continue Recording. A voice
confirmation that the recording is resumed is played 'The conference recording is resumed' and the Continue
Recording option in the menu turns back into Pause Recording, as shown in Figure 2-13 (Continue Recording).
19