1
Download SATA User Guide - Digi-Key
Transcript
Board Components 3.5 SATA/SAS 4 Lane Channel 1-9 This section describes SATA/SAS 4 lane channel on the SATA/SAS card A 32 pins signal connector is used for SATA/SAS quad channel link. The connector contains 16 high-speed differential signals for SATA/SAS communications protocol. There are 10 pins used for signal ground and 6 pins for sideband signals. Figure 3.5 shows the block diagram of the SATA/SAS 4 lane channel. Figure 3.5 block diagram of the SATA/SAS 4 lane channel 19
