Download manual

Starting NetBeacon from Sun Solaris and HP-UX
To start NetBeacon under UNIX, do the following:
1. Open a terminal window.
2. If you installed NetBeacon using the default directories, type one of the following
commands at the prompt:
/opt/NBeacon/NBeacon.sh to start the NetBeacon client/server or server application.
/opt/NBClient/NBClient.sh to start the NetBeacon client application.
If you did not use the default directories, replace /opt/NBeacon and /opt/NBClient
with the location where you installed the NetBeacon software in the commands above.
HP OpenView Network Node Manager
Operating Systems
•
Windows NT
•
Sun Solaris 8
•
HP-UX 11.00
1. Start HP OpenView Network Node Manager. The Radiance/Lancast device icons appear
as connectors (buttons or icons) on the HP OpenView map.
Tip:
Not all connector icons that appear on the map represent Radiance or Lancast
devices.
2. Do one of the following:
•
Click the icon, and then choose NetBeacon from the Tools menu.
Or:
•
Double-click any Radiance or Lancast device button on your HP OpenView map.
Important: You must associate the NetBeacon application to the selected device,
before you start NetBeacon this way.
To create an association, do the following:
1. Right-click the Radiance or Lancast device icon.
NetBeacon Management Software ~ Installation and User's Guide
21