Download "user manual"

SPECIFICATIONS
1
This flag turns on for the AJ65SBT2B-64DA to request the initial data setting after
power-on.
RX(n+1)8
Initial data processing request flag
RY(n+1)8
Initial data processing completion flag
3
RX(n+1)9
Initial data setting completion flag
SPECIFICATIONS
RY(n+1)9
Initial data setting request flag
RY(n+1)B
Remote ready flag
CH
Range setting (RXn4 to RYnF)
4
PROCEDURES AND
SETTINGS BEFORE
OPERATION
CH HOLD/CLEAR setting
(RY(n+1)0 to RY(n+1)3)
CH
2
SYSTEM
CONFIGURATION
The flag turns off when the initial data processing is completed (Initial data processing
completion flag (RY(n+1)8) turns on).
OVERVIEW
(5) Initial data processing request flag (RX(n+1)8)
Conversion enable/disable setting
(RY(n+1)4 to RY(n+1)7)
: Performed by sequence program.
: Performed by the AJ65SBT2B-64DA.
Figure 3.5 Operation at initial setting
5
This flag turns on after the initial data setting is completed when initial data setting has
been requested (Initial data setting request flag (RY(n+1)9) is turned on).
The flag turns off when Initial data setting request flag (RY(n+1)9) is turned off after
the initial data setting is completed.
6
APPENDIX
TROUBLESHOOTING
For details on initial data setting, refer to Figure 3.5.
PROGRAMMING
(6) Initial data setting completion flag (RX(n+1)9)
INDEX
3
3.5 Remote I/O Signals
3.5.2 Details of the remote I/O signals
3 - 15