Download RollView User Manual

Transcript
RollView User Manual
Configuring RollView
Keyword
Description
TIME / UCT The LogServer program generates two time keywords for each unit in the
current status file. The first is TIME. This is the ASCII version of the time at
which the event was logged according to LogServer using its local PC time.
However, this TIME field when viewed by a LogViewer on a PC in a different
time zone (Wide area network system), indicates incorrect local time. The
second keyword is UCT (Universal Co-coordinated Time). This is a numerical
value indicating the number of seconds elapsed since 1st January 1970.
LogViewers can use this value to generate local or GMT time depending on its
own time zone settings.
For example: If a LogServer in San Francisco, California, USA is configured to
collect information on a network of RollCall units, it may generate an entry
similar to the one below for an IQD1FPG.
NAME=01:IQD1FPG-0,ADDRESS=0000:A0:01,TIME=Thu Apr 30
10:52:41 1998,MSG=Unit present, UCT=893929961, EXTREF=N/A,
STD=625, SN=270207,
The time that the event occurred was Thu Apr 30 10:52:41 1998. This is in San
Francisco local time. If a monitoring site in Rome, Italy, was configured to view
the same status file as generated by the LogServer in San Francisco, then the
monitoring site in Rome would also see Thu Apr 30 10:52:41 1998 which is
wrong respective to Rome local time. In order to adjust for local time anywhere
in the world, the UCT header keyword should be used instead. Each PC should
have its Time Zone variable set either by the environmental variable TZ or by
setting it within the COMMTROL program. (See COMMTROL: Setting Time
Zone). If the Time Zone for San Francisco is set to GMT+8, and Rome to
GMT-2, then the LogViewer in San Francisco automatically converts the UCT
value (in this example 893929961) into the ASCII string Thu Apr 30 10:52:41
1998. The LogViewer in Rome converts the same UCT value to Thu Apr 30
20:52:41 1998. The LogViewers also have the options of showing the UCT
value in GMT time which is identical for both sites (Thu Apr 30 18:52:41 1998
GMT).
Table 1.
Note:
Issue 3 Rev 1
Special Keyword Headers
Keyword headers can be overridden in the unit list. See “Override Keyword Headers” on
page 54.
Page 17
© 2015 SAM