Download ARTDriveL
Transcript
IPA Description [Unit] Access Default Min Max Format Reg. Mode TRAVEL / DC braking DC current injection can help to stop the motor and ensure that lift car arrives exactly at floor level. 1836 DCbrake cmd src N/A RWS IPA 7125 List 3 PIN V-F-S-B IPA 7125 Lift DC Brake mon = Default It allows to select the origin of the signal to command DC braking function, normally if is controled by lift sequence. (refer to signals List 3 of Pick List manual) 1833 DCbrake delay [sec] RWS 0.1 0.01 30 PP Delay between the injection command and the injection of the current itself V-F-S-B 1834 DCbrake duration [sec] Duration of the current injection 1835 1837 30 PP V-F-S-B DCbrake current [%] RWS 100 0 Braking current as a percentage of Drive continuos current 100 PP V-F-S-B DCBrake state N/A 0 non-active 1 active State of DC Brake functon. 1 DV V-F-S-B NOTE! RWS R 1 0 0.01 0 Sequence available only when IPA 7105 set as Start fwd/rev. Lift DC brake mon signal that controls DC current braking is not available. Speed ref Speed 0 ref thr t DC brake cmd src Speed 0 ref dly + Brake close dly Lift DC brake mon Output current DC brake delay DC brake duration A DC brake current B DC brake state 1 0 A = DC brake delay + DC brake duration > Spd 0 ref dly + Brake close dly B = DC brake delay + DC brake duration < Spd 0 ref dly + Brake close dly 148 • Chapter 9 Parameter ARTDriveL Instruction Manual