Download ARTDriveL

Chapter 4 - Wiring Procedure
4.1 Accessing the Connectors
4.1.1 Removing the Covers
NOTE!
Observe the safety instructions and warnings given in this manual. The devices
can be opened without the use of force. Only use the tools specified.
Figure 4.1.1: Removing the Covers (Sizes 1007 to 3150)
3
2
2
no. 2 for
20-40 ...30-60
size
1
Sizes 1007 to 2075:
The terminal cover and cable entry plate of the device must be removed in
order to fit the electrical connections:
- unscrew the screw (1), remove the cover of devices (2) by pressing on
both sides as shown on the above figure (3).
- unscrew the two screws (4) to remove the cable entry plate.
The top cover must be removed in order to mount option cards and change
the internal jumper settings:
- remove the keypad and disconnect the connector (5)
- lift the top cover on the bottom side (over the connector level) and
then push it to the top (6).
Sizes 3110 to 3150:
The terminal cover and cable entry plate of the device must be removed in
order to fit the electrical connections:
- unscrew the two screws (1) and remove the cover of devices
- unscrew the two screws (4) to remove the cable entry plate.
The top cover must be removed in order to mount the option card and
change the internal jumper settings:
- remove the keypad and disconnect the connector (5)
- lift the top cover on the bottom side (over the connector level) and then
push it to the top (6)
ARTDriveL Instruction Manual
Chapter 4 Wiring Procedure • 35