Download 64SPU-1 Data Sheet

Transcript
3. Check 3 – MD03 motor controller I2C WRITE comms checks – stage-1
Configuration
As for Check 2 above with feedback devices connected and trip loop by-passed, and additionally:
•
Power-down the 64SPU-1
•
DO NOT make ANY connections to the high current motor/24V supply end of the MD03's.
•
In the PID26.cfg file enable I2C Write (bit 7 = 0)
Test
Power up the 64SPU-1 and start the motion driver and PID Servo Controller as before.
Confirm that the servo loop is operating normally and steadily.
This stage 1 check is to confirm that I2C writes to the MD03's does not disrupt the servo loop
operation.
If this is so – move on to Check 3 – stage 2.
12