Download NA Series Programmable Terminal Software User`s Manual

3 HMI Configuration and Setup
3-4-6
FINS Settings
These are the settings for FINS communications.
These settings are required when FINS communications are used between the HMI and a CJ-series
PLC.
3-4 HMI Settings
3
3-4-6 FINS Settings
Item
FINS Address
Ethernet port #1
Ethernet port #2
Description
Sets the FINS network address of Ethernet port 1.
The FINS node address is automatically created from the IP address.
Sets the FINS network address of Ethernet port 2.
The FINS node address is automatically created from the IP address.
FINS/UDP
FINS/UDP port no
Remote Network Table
Displays the port number used for FINS/UDP.
Sets the routing table.
NA Series Programmable Terminal Software User’s Manual (V118)
3 - 15