Download Controller 218M for milling

GSK218M CNC System
Connection and PLC Manual
=0:
MCM
Setting a workpiece zero point offset value by MDI key input during halt state is
not disabled.
=1: The setting of custom macros by MDI key operation is enabled only during the
MDI mode.
=0: The setting of custom macros by MDI key operation is enabled regardless of the
mode.
System parameter number
0 2 8
MCL
MKP
MKP =1:
=0:
MEE =1:
=0:
MER =1:
=0:
The written program is cleared when M02, M30 or is executed in MDI mode.
The written program is not cleared when M02, M30 or is executed in MDI mode.
The program is not edited during operation in MDI mode.
The program can be edited during operation in MDI mode.
The program can be edited during operation execution in MDI mode.
The executed program is not deleted when the last has been executed in MDI
mode.
MCL =1: Upon the reset key, the written program is deleted during MDI mode.
=0: Upon the reset key, the written program is not deleted during MDI mode.
System parameter number
0 3 0
=1:
=0:
MAB =1:
=0:
ABS =1:
=0:
DPI
ABS
MAB
DPI
The decimal point during programming is omitted: mm, sec.
The decimal point during programming is omitted: min. setting unit.
Use parameters to set the absolute or relative during MDI mode.
Use G90/G91 to set the absolute or relative during MDI mode.
The instruction is absolute during MDI mode.
The instruction is relative during MDI mode.
4.17 Parameters of tool compensation
System parameter number
0 3 9
EVO
=1：
=0：
EVR =1：
=0：
EVO =1：
=0：
TLC
EVR
Tool length compensation: B
Tool length compensation: A
Enables the change, starting from that block where buffering is next performed.
Enables the change, starting from that block where the next block is specified.
A block to be buffered next and subsequent blocks becomes valid.
A block specifying the next becomes valid.
System parameter number
0 4 0
ODI
SUP
TLC
CCN
=1: Start up during tool nose radius compensation : B
=0: Start up during tool nose radius compensation: A
156
SUP