Download SmartCAM Installation Guide

For further information about licensing SmartCAM applications, please refer to the following FAQ:
http://www.SmartCAMcnc.com/Technical_Support/Tech_Bulletins/techbulletin.php?tbnum=50
After you have imported your license key file, you can move to the next step and run the
application.
Run the Application
After you enter your temporary license key, you can run your SmartCAM application until the
license key expires. The temporary key is provided to allow you to run the application while you
wait for your long-term key. After you enter your long-term license key, the application license will
not expire.
To run an installed SmartCAM application, open the Windows Start menu. Select the All
Programs pull-right menu. This menu will contain a SmartCAM program group (unless you ran a
Custom installation type and changed the name).
Open the SmartCAM program group and select the SmartCAM application to run.
Post Installation Activities
At this point, you may delete the SmartCAM application installation package. This is the
executable that you downloaded from the SmartCAMcnc Downloads page.
If you think that you might want to rerun this installation again, perhaps using to fix any
inadvertent changes to application files, do not delete the installation file.
If you want to delete the installation package and later find that you need to reinstall, simply
download the file again.
SmartCAM Installation Guide
13