Download 1 HEADING 1

Transcript
37
44
SIREN AND SYSTEM SUPERVISION
Segment 1 (Circle Numbers To Program)
1
Reserved
2
3
4
5
6
7
Reserved
Siren blast at arming (pulse)
Siren blast at exit delay expiration (pulse)
Siren blast at closing kissoff (pulse)
Siren sounds during a cross zone verification time
Siren sounds for a tamper
8
Siren blast once for keyswitch arming, twice for disarming
Segment 2 (Circle Numbers To Program)
Convert siren driver to voltage out
Siren sounds for expander trouble
Zones to always restore
Dynamic battery test performed upon arming
Battery missing test performed every 12 seconds
1
2
3
4
5
6
7
8
1
2
3
38
45
Manual bell test performed during [*]-[4]-[4]test function
Manual communicator test performed during [*]-[4]-[4] test function
Box tamper enabled
Segment 3 (Circle Numbers To Program)
Box Tamper report enabled
AC Fail report enabled
Low Battery report enabled
4
5
6
7
8
Auxiliary power overcurrent report enabled
Siren supervision report enabled
Reserved
A+B Alarm (for Norway and Sweden only)
Expander trouble report enabled
Segment 4 (Circle Numbers To Program)
1
2
3
4
5
6
7
Failure To Communicate report enabled
Log Full report enabled
Autotest report enabled
Start and End Programming report enabled
End Download report enabled
Sensor Low Battery report enabled
Sensor Missing report enabled
8
1
2
3
4
5
Autotest report enabled ONLY when system is armed
Segment 5 (Circle Numbers To Program)
Lost Clock service LED enable
Reserved
Disable six on-board zones
Enable two trips on the same cross-zone to activate the alarm
Disable bypass reports for force armed zones
6
7
8
Silent exit
Reserved
Automatic switch summer/wintertime and vice versa
SWINGER COUNTDOWN COUNT
NX-4 Installation manual
0
Page 69
Date 13/03/04