Download SYSTEM ADMINISTRATOR`S GUIDE
Transcript
Chapter 4—SMS-3000 Installation Chapter 4—SMS-3000 Installation Security Keys Each copy of SMS-3000 software is shipped with a hardware security key. You must install the security key on the LPT1 parallel port of the POWERLOGIC network server computer before you can use SMS. To ensure that the security mechanism is properly registered, be sure to install the key before starting the installation process. Note: Only the server PC requires a security key. Client software does not require a key, but a software serial number must be entered at installation. The serial number is printed on a sticker on the back of the software CD jewel case. Once installed, a client does not need to use a unique serial number to connect, but the POWERLOGIC server will not let more clients log on than are specified by the installation. SMS-3000 allows one connection for a client and one connection for DDE per unique serial number (per each client purchased.) If two client packages are installed, you can connect two concurrent clients and two concurrent DDE servers (DDE does not have to be on the same PC as the server or any other client). See the Client Installation section in chapter 4 for the complete client installation procedure. To install the security key, complete the following steps: 1. If a cable is plugged into the LPT1 port, unplug it. 2. Plug the male end of the security key into the LPT1 port (server installation only). To ensure that it will be recognized, the software key must be behind any other keys. 3. Using a small screwdriver, tighten the screws on the sides of the key. 4. If you unplugged a cable from the LPT1 port in step 1, plug it into the security key. If the key is not plugged in, SMS displays the message “No key found.” No Key Found If you attempt to run the program and the security key is not installed, SMS displays the message “No key found” in the active alarms list. If this message appears, exit the program. Install the security key as described above and restart. Planning the Installation There are several factors that you must consider before you attempt to install SMS. You must take into account hardware issues, such as how many computers you will be using and how they will connect with devices. You also need to determine naming conventions, routing, and device numbers for hardware. For additional information about designing your system, refer to the Power Monitoring and Control System Planning Guide (order no. 3000CT9601). A .pdf copy of this manual is in the Documents folder on the installation CD. © 1997 Square D All Rights Reserved 11