Download RoboScan Pro 918

Transcript
Adjusting mirror dampers
If the dampers are too loose, the mirror may lose step at high speeds. If the dampers are too tight, mirror movement
will not be smooth at low speeds.
1.
Loosen both dampers until the spring-loaded pin no longer touches the motor.
2.
Turn on the lamp and focus the beam. Using a controller, pan the mirror slowly and watch the
beam movement. Tighten the pan damper until the smoothness of the mirror movement is
affected and it becomes “twitchy.” Loosen the damper slightly.
3.
Use the same method to adjust the tilt damper.
Maintenance schedule
The maintenance schedule will depend heavily on the application and should be discussed with your Martin technician. Cleaning and servicing the fixture is best left to a qualified technician. He has the experience, tools, lubricants
and other materials required to keep the RoboScan Pro 918 performing at its best.
Cleaning optical components
Be very careful when cleaning the optical components. The colored surface on the dichroic filters is achieved by
means of special multi-layer coatings and even small scratches may be visible. Residues from cleaning fluids can bake
onto components and ruin them.
1.
Allow the components to cool completely.
2.
Wash dirty lenses and filters with isopropyl alcohol. A generous amount of regular glass cleaner
may also be used, but no residues may remain.
3.
Rinse with distilled water. Mixing the water with a small amount of wetting agent such as Kodak
Photoflo will help prevent streaking and spotting.
4.
Dry with a clean, soft and lint-free cloth or blow dry with compressed air.
Cleaning the fans
To ensure proper cooling of the fixture, it is important that the fans are free of dust. Vacuum or gently wipe the fans
clean if they are dirty.
Lubricating the focus slide pins
The focus mechanism slides on 2 metal pins that must be lubricated periodically. Check the focus mechanism whenever the fixture is open for service and lubricate the slides if movement is rough.
1.
Fill a syringe with Martin P/N 400003 synthetic, high-temperature oil.
2.
Apply a few drops of oil to both slides. The oil will be distributed by the action of the focus mechanism. Be careful not to get oil on drive belts or other parts.
Basic Service and Maintenance
21