Download Partner ACS R1 Programming and Use
Transcript
Hold Disconnect Time (#203) Description This System Programming procedure lets you change the hold disconnect time for an outside line. When a caller on hold hangs up, the local telephone company may send a special signal to the system to free the line. Different telephone companies use different length signals. The length of the signal is called the hold disconnect time. If you put a call on hold and the caller hangs up, but the call does not disconnect within a minute after the caller hangs up, the hold disconnect time is probably set too high, or set at No Detection. Considerations If the telephone company does not send a signal, keep the hold disconnect time set to 450 msec, the default setting. The user must disconnect a held call manually by retrieving the call then hanging it up. Shorten the hold disconnect time only if abandoned calls on hold do not disconnect. Lengthen the hold disconnect time only if calls are being disconnected prematurely. Valid Entries 00 01 02 03 04 05 06 07 08 09 10 11 12 = = = = = = = = = = = = = No Detection 50 msec 100 msec 150 msec 200 msec 250 msec 300 msec 350 msec 400 msec 450 msec ✔ 500 msec 550 msec 600 msec Hold Disconnect Time (#203) 5-97
Related documents
PARTNER® II Communications System Release 4.1
PARTNER® - MC Telecom
Partner Plus R4 Installation Programming and Use
Partner ACS Programming and Use
PARTNER Advanced Communications System Quick
Avaya 700217243 Telephone User Manual
PARTNER Advanced Communications System
PARTNER Advanced Communications System
PARTNER Advanced Communications System
Lucent Technologies 518-458
GT-C2431取扱説明書
Lucent Technologies Computer Hardware partner voice messaging card User's Manual