Download "user manual"

5
I/O Link Interface Module Configuration
The I/O Link Interface module provides an interface between the Series 9 0-30 PLC and
the Fanuc I/O Link. This module operates as a slave device. The module can be
configured as a 32 point or 64 point Input and Output (combination) module by
positioning a jumper on the board. When set for 64 I/O points, the module will be
configured with the HHP using the same key sequences and displays that are used to
configure the 64-point generic I/O module.
For more information on assigning I/O references, see page 5-10, Assigning Reference
Addresses to I/O Modules.
Configuration Sequence
The following examples show the key sequences and resulting displays with which to
configure the I/O Link Interface module when it is set for 32 I/O points.
Initial display:
Press the
Press the
Press the
A I
AI
B
Q
AQ
ENT
key:
key:
key:
R0:02 EMPTY
<S
R0:02 I _
<S
R0:02 QI _
<S
R0:02 QI _
QI _
<S
Note that the I/AI and Q/AQ keys could have been pressed in the reverse order with the
same result; a module type of QI.
Press the key sequence:
3
2
ENT
R0:02 QI
QI32: I _
<S
At this point the desired reference address can be entered. The same restrictions apply
to the I/O Link Interface modules as to any other I/O Modules. In addition, since the %I
GFK-0402G
Chapter 5 I/O Configuration
5-15