1
Download "user manual"
Transcript
5 Note that the 32 references associated with node 19, G0097 - G0128, are now lost to the user. 11. Press the Right cursor key to display node 20. Then, press the key sequence 1 2 8 . R0:06 GCM BA20<S G 128_ 12. Press the ENT key: R0:06 GCM BA20<S G128:G0129–G0256 Since all 256 bits are now accounted for, you will not be allowed to view the settings for nodes 21, 22, or 23, or make assignments to them. Creating a Generic Module Configuration The G/S key may be used to configure a slot for a Genius Communications module not currently installed in the slot. 1. With slot 6 displayed in its initial state as empty, press the G/S key: R0:06 GCM_ 2. Then, press the ENT key. The same default configuration is established, as previously described. R0:06 GCM BUS ADR: 16 5-20 <S <S Hand-Held Programmer for Series 90-30/20/Micro Programmable Controllers User’s Manual – February 1996 GFK-0402G
