Download BenchCel X-Series User Guide

Transcript
Chapter 6: Setting task parameters
BenchCel User Guide
Related information
For information about...
See...
The workflow that this procedure
belongs to
“Workflow for creating a protocol” on
page 85
Adding tasks to protocols
“Adding and deleting tasks and pipette
tasks” on page 92
Using JavaScript with BenchWorks
“Using JavaScript in BenchWorks” on
page 171
Signal tasks
“Setting Waitfor task and Signal task
parameters” on page 127
Pipette tasks
“About setting pipette task parameters”
on page 96
Other tasks
“About setting task parameters” on
page 95
Setting Waitfor task and Signal task parameters
About this topic
This topic describes how to set the Waitfor and Signal task parameters
for the BenchCel.
Read this topic if you are:
❑ An administrator or technician who writes protocols for the
BenchCel
❑ An operator who runs protocols and may need to set the parameters
for this task
Waitfor and Signal
tasks defined
The Waitfor task and a Signal task work together to specify the order in
which tasks are performed across processes.
You must first set the Waitfor task and then set the Signal task.
Procedure
To set Waitfor task parameters:
1. Add a Waitfor task to a protocol process.
2. In the Protocol Task Parameters toolbar, type a name for the task.
To set Signal task parameters:
1. Add a Signal task to a protocol process.
2. In the Available waitfors text box of the Protocol Task Parameters
toolbar, select the Waitfor task that you want to reference.
127