Download HARDWARE USER`S MANUAL

Transcript
January 2013
controller. Zip-tie the dummy exit cable and the status cable to the other cable tie-down at the
end of the controller.
After all the LED cables and the dummy exit cable are connected, the cover on the bottom end of
the controller can be re-installed. Two M3x50 socket-head cap screws attach the cover top to the
base. Two M3x8 socket-head cap screws attach the cover at the end of the controller. The cover
screw locations were shown previously in Figure 20.
2.3.4 Sensor cables
Route the sensor cables between the ribs toward back of dummy, as shown in Figure 24. Then
route the cables along the inside of the outer ribs toward the dummy’s head, as shown in Figure
25. Zip-tie the cables to the inside of the outer rib as close to the spine plate as possible.
Figure 24. Sensor cables routed to back of dummy
28
© 2013 Boxboro Systems LLC