1
Download ATCA-7367 BBS Programmer`s Reference Guide
Transcript
Clock Agent Command Module You can use AUTO_CONF_1 conf id to automatically detect the presence of the AMC, its type (CGM or not), and the slot position (left/right logical slot position). Based on this information it performs following setup: 9.2.4 If AMC in the bay is CGM - set the AMC CGM mode. – If left AMC slot (odd slot) - enable clock buffer 1A and 2A. – If right AMC slot (even slot) - enable clock buffer 1B and 2B. If AMC in the bay is Line Card or not present - set system clock to CLK1. LCCB Mode Description This command sets the SONET or SDH mode in LCCB. Synopsis clkcmd -L -m <LCCB mode id> Parameters Table 9-4, describes the LCCB mode id. Table 9-4 LCCB mode id Mode id Description SDH Setup the on-board LCCB to work in SDH mode. SONET Setup the on-board LCCB to work in SONET mode. Example To set the LCCB operating mode to SONET. clkcmd -L -m SONET Basic Blade Services Software on ATCA-7367 Programmer’s Reference (6806800K69F) 151
