Download Technichal manual DGT1

DGT series indicators
DGT _07.01_12.09_EN_T
• L.int DISPLAY BACKLIGHT INTENSITY (§)
Through this step one selects the intensity of the backlighting or of the LED display:
Lint 1 (minimum), Lint 2, Lint 3, Lint 4 (maximum).
(!) Lint 1
(§) The parameter is displayed with the DGT60 model.
• CLoCK DATE/TIME ADJUSTMENT (OPTIONAL) (§)
In this step one sets the date and time of the indicator; by pressing PRINT one is asked to enter, in this order, the
day, month, year, hour and minute.
The entry of each parameter must be confirmed with PRINT.
(§) The parameter is not displayed if there is no date/time option or if the rEPE functioning mode has been
selected, F.ModE >> FunCt parameter.
NOTE: The date/time function is standard fitted in the DGTP/DGTPK version.
• tArE LOCKED / UNLOCKED / DISABLED TARE SELECTION (§)
LoCK locked tare
unLoCK unlocked tare
diSAb disabled tare
See the "TARE OPERATIONS" section for further functioning details, USER MAN. REF..
(!) LoCK
(§) The parameter is displayed only in the STANDARD type firmware.
• AutoFF AUTO SWITCH-OFF (§)
It is possible to enable the automatic switch off of the indicator (from 1 to 255 minutes), or disable it; the auto
switch-off starts working when, with unloaded scale, the weight has not been moved or a key has been pressed
during the set time: the display shows the blinking "- oFF – " message, then the indicator turns off.
diSAb auto switch-off disabled.
EnAb auto switch-off enabled (one will be asked to enter the number of minutes after which the indicator
must turn off: enter a number from 1 to 255).
(!) diSAb
(§)The parameter is not displayed if one has selected the rEPE functioning mode in the MASTER type firmware,
F.ModE >> FunCt parameter.
SEtuP SCALE CONFIGURATION
• ConFiG METRIC CONFIGURATION(§)
(§) The parameter is displayed only in the STANDARD type firmware.
(*) nChAn SELECTION OF NR. OF INDICATOR CHANNELS (§)
1÷4 in SCALE WITH NON DEPENDENT CHANNELS functioning mode ("ind.Ch" / "trAnSM")
2÷4 in SCALE WITH DEPENDENT CHANNELS functioning mode ("dEP.Ch")
(!) Ch. 1
(*) With approved instrument the parameter is read-only.
(§) The parameter is not displayed with the DGT1 model.
ChAn SELECTION OF THE ACTIVE CHANNEL (§)
1÷4 in SCALE WITH NON DEPENDENT CHANNELS functioning mode ("ind.Ch" / "trAnSM")
(§) The parameter is not displayed if one has set "dEP.Ch" in the tYPE parameter or in case of a single
channel application, SEtuP >> ConFiG >> nChAn step.
17