Download ANSI® Programmer`s Reference Manual
Transcript
Flash Memory Message Guide Flash Memory Message Guide Message Explanation Required Action CLEARING PROGRAM FROM FLASH The program successfully loaded into printer RAM and the checksum matched. The old program is now being deleted from flash memory. None DIAGNOSTIC PASSED The printer passed its memory and hardware initialization tests. None ERROR: DC PROGRAM NOT VALID Printer cannot find the data controller program or the validation checksum is corrupt. 1. Download the program again. ERROR: DRAM AT ADDRESS XXXXXXXX The printer found a defective memory location. Replace the DRAM. ERROR: EC PROGRAM NOT VALID Printer cannot find the engine controller program or the validation checksum is corrupt. 1. Download the program again. ERROR: EC STOPPED AT STATE XXXX Hardware fault in the engine controller. Replace the CMX controller board. ERROR: FLASH DID NOT PROGRAM The printer could not find any flash memory. 1. Download the program again. 2. If the message occurs again, replace the flash memory. 2. If the message occurs again, replace the flash memory. 2. If the message occurs again, replace the flash memory. ERROR: FLASH NOT DETECTED The printer could not find any flash memory. Install flash memory before attempting to download this program. ERROR: NO DRAM DETECTED The printer could not find any DRAM. Check DRAM on CMX. If present, reseat DRAM. If missing, install DRAM. ERROR: NVRAM FAILURE The non-volatile memory has failed. Replace the CMX controller board. (Do NOT attempt to replace NVRAM.) ERROR: PROGRAM NEEDS MORE DRAM The printer requires more DRAM memory in order to run the downloaded program. Add DRAM or use a smaller emulation program. 19