Download Agilent 33220A 20 MHz Function / Arbitrary Waveform Generator
Transcript
users_guide_33220a.book Page 143 Wednesday, September 29, 2004 2:20 PM Chapter 3 Features and Functions Calibration Overview To Change the Security Code To change the security code, you must first unsecure the function generator, and then enter a new code. Make sure you have read the security code rules described on page 141 before attempting to change the security code. • Front-Panel Operation: To change the security code, unsecure the function generator using the old security code. Then press and select the Secure Code softkey from the “Test / Cal” menu. Changing the code from the front panel also changes the security code as seen from the remote interface. • Remote Interface Operation: To change the security code, you must first unsecure the function generator using the old security code. Then enter the new code as shown below. CAL:SECURE:STATE OFF, AT33220A CAL:SECURE:CODE SN123456789 Unsecure with old code Enter new code Calibration Count You can query the function generator to determine how many calibrations have been performed. Note that your function generator was calibrated before it left the factory. When you receive your function generator, be sure to read the count to determine its initial value. • The calibration count is stored in non-volatile memory and does not change when power has been off or after a remote interface reset. • The calibration count increments up to a maximum of 65,535 after which it rolls over to “0”. Since the value increments by one for each calibration point, a complete calibration may increase the value by many counts. • Front-Panel Operation: Press and then select the Cal Info softkey from the “Test / Cal” menu. The calibration count is listed as one of the messages on the display. • Remote Interface Operation: CALibration:COUNt? 143 3