Download User Manual

Support of additional data terminals
If there is power present at the terminal (Text
appears on the display) and it is connected properly a message appears in the INFO-Box below
the clock that states that the terminal is active:
When the power supply to the terminal is interrupted, the message disappears. If the wires
A and B from the terminal have been swapped
by mistake an error message appears and the
terminal will be deactivated:
To resolve the problem swap the two wires and
restart the IXARO software. (Do not swap the
power supply polarity by mistake).
Label on the backside
of a SLAVE terminals
„LKWAUF“.
ATTENTION: There are two versions of the Terminal “LKWAUF”, MASTER and SLAVE terminals.
Only MASTER terminals are able to operate autonomous. SLAVE terminals can only be used as
additional data entry points in conjunction with a
master terminal. You can recognize the versions
on their label. The software version of a SLAVE
terminal has the suffix „S“ like in the following
picture. The MASTER version has suffix “M”:
S
O
L
U
The designation
of a MASTER terminal is
„SW: A_LKW_M“
T
I
O
N
S
33