Download User`s Manual

Transcript
5. Each Component Function
I/O Addresses and Instructions
* 4000h: General-purpose I/O
D7
D6
Figure 5.12.
D5
D4
D3
D2
D1
D0
PIO2
PIO1
PIO0
R/W
General-purpose Input Port (4000h)
R : Read data from PI0, PI1 and PI2.
W : Set data to be output to PO0, PO1 and PO2.
* 4001h (bit0-3): PI2/IRQ(14) event input control
D7
D6
D5
D4
D3
D2
D1
D0
WD_S1
WD_S0
PO2_M
RESET
PIM2
PIM1
PIM0
Figure 5.13. Event Input Control Port (4001h)
Table 5.16. PIM2 - PIM0 : Interrupt output mode
PI2/IRQ (14) interrupt input
RIM2
RIM1
RIM0
0
0
1
Input the RAS connector's PI2/IRQ (14) signal to IRQ5.
0
1
0
Input the RAS connector's PI2/IRQ (14) signal to IRQ7.
0
1
1
Reserved * Do not set this value.
1
0
0
Input the RAS connector's PI2/IRQ (14) signal to IRQ10.
1
0
1
Input the RAS connector's PI2/IRQ (14) signal to IRQ11.
1
1
0
Input the RAS connector's PI2/IRQ (14) signal to NMI.
Others
Table 5.17.
Inhibit the RAS connector's PI2/IRQ (14) signal interrupt to be
set.
RESET: RESET: Reset Input Modes
RESET
PI2/IRQ (14)'s RESET input
0
Inhibit the remote reset input function of the RAS connector's PI2/IRQ (14) signal.
1
Use as the remote reset input function of the RAS connector's PI2/IRQ (14) signal.
CAUTION
A bit indicated with "rsv" is used by the system. Do not modify the bit.
108
BX710 series User’s Manual