Download User`s Manual
Transcript
5. Each Component Function I/O Addresses and Instructions * 4000h: General-purpose I/O D7 D6 Figure 5.12. D5 D4 D3 D2 D1 D0 PIO2 PIO1 PIO0 R/W General-purpose Input Port (4000h) R : Read data from PI0, PI1 and PI2. W : Set data to be output to PO0, PO1 and PO2. * 4001h (bit0-3): PI2/IRQ(14) event input control D7 D6 D5 D4 D3 D2 D1 D0 WD_S1 WD_S0 PO2_M RESET PIM2 PIM1 PIM0 Figure 5.13. Event Input Control Port (4001h) Table 5.16. PIM2 - PIM0 : Interrupt output mode PI2/IRQ (14) interrupt input RIM2 RIM1 RIM0 0 0 1 Input the RAS connector's PI2/IRQ (14) signal to IRQ5. 0 1 0 Input the RAS connector's PI2/IRQ (14) signal to IRQ7. 0 1 1 Reserved * Do not set this value. 1 0 0 Input the RAS connector's PI2/IRQ (14) signal to IRQ10. 1 0 1 Input the RAS connector's PI2/IRQ (14) signal to IRQ11. 1 1 0 Input the RAS connector's PI2/IRQ (14) signal to NMI. Others Table 5.17. Inhibit the RAS connector's PI2/IRQ (14) signal interrupt to be set. RESET: RESET: Reset Input Modes RESET PI2/IRQ (14)'s RESET input 0 Inhibit the remote reset input function of the RAS connector's PI2/IRQ (14) signal. 1 Use as the remote reset input function of the RAS connector's PI2/IRQ (14) signal. CAUTION A bit indicated with "rsv" is used by the system. Do not modify the bit. 108 BX710 series User’s Manual