Download manual 1 - Digitimer

INSTRUTECH CORPORATION
VR-10B USER’S MANUAL
After power up the VR-10B LCD will sequentially display:
MODEL VR-10B PCM
PROG. STIMULATOR
REV. 1.0 <NTSC> or <PAL>
COPYRIGHT 1992
INSTRUTECH CORP.
MADE IN U.S.A.
TO ENABLE OUTPUT
PRESS FR/MEM
XX:XX:XX:XX REC
* The XX denotes a variable number.
REC denotes the record mode. The digits displayed at this time should start
counting frame numbers. An alternate display of CHECK VCR could be seen
here in place of the incrementing frame numbers, if this is the case then there is a
problem with the video connections, the VCR is not turned on, or the VCR is
improperly set up. Another possible message at this point is ERROR-ON
SCREEN. If this is displayed it indicates that the VCR has an on screen
programming message being superimposed on the video data. This message must
be cleared and the on screen programming disabled for the VR-10B to operate
correctly. If the either of the above problems exist it must be corrected before
continuing. For normal operation the VR-10B display should remain in the REC
mode with the frame number incrementing.
VCR VIDEO
OUT
IN
Ch 3
In from
antenna
Ch 4
Channel
select
VCR AUDIO
OUT IN
EXPANSION
COMPUTER
UHF
To TV
From antenna
S/N: ___________
Made in U.S.A.
100-220V
47-400 Hz FUSE
2A
Line
IN OUT
VIDEO
Out to
TV
VHF
INSTRUTECH CORP.
475 Northern Blvd.
Great Neck, NY 11021
(516) 829 - 5942
IN OUT
AUDIO
AC Line Voltage
120 VAC 35 Watts
Tuner
Input
select
ACME Video Cassette Recorder Company
Model Number VCR-2001
Made in Japan
Figure 6. VR-10B to VCR Connections
24