Download installation manual - ADSF
Transcript
19) FUNCTIONS AND SETTINGS To enter, type 10-character technical password (for more information, refer to “Password management” paragraph) The buttons in this sub-menu are used as follows: button F2 = to access the F function setting (see the “Function setting” paragraph); button = to access the P parameter setting (see the “Parameter setting” paragraph); button F1 = issue the door opening command; button F3 = it is only used in case the S12 digital programmer is connected to two operators, to choose whether to act on the functions and parameters of operator 1, or of operator 2. The number 1 or 2 at the top right of the display indicates the selected operator. If the S12 programmer is connected to a single operator, the number 1 appears at the top right of the display. button = to return to the general programming menu. 19.1) FUNCTION SETTING In this section the display describes the purpose of the selected function; the F1 button sets the function status to OFF; the F3 button sets the function status to ON; the F2 button allows to switch to the next function; the button allows to return to the previous function; For information about the operation of each function, please refer to the "FUNCTION TABLE" below. 19.2) PARAMETER SETTING In this section the display describes the selected parameter type; the F1 button decreases the set percentage value; the F3 button increases the set percentage value; the button allows to switch to the next parameter; the F2 button allows to return to the previous parameter. For information about the operation of each parameter, please refer to the "PARAMETER TABLE" below. 38